On the horizon: a 'rinse' for washing machines that dries clothes

Image: University of Florida chemical engineering doctoral student Daniel Carter demonstrates how a homeowner might pour a clothes-wringing solution into a washer. Carter and Dinesh Shah, a professor of chemical engineering, developed the solution, which forces clothes to shed 20 percent more water during the washer’s spin cycle than under normal conditions. The result: A load of clothes dries faster in the dryer, saving energy and reducing homeowners’ electricity bills. (University of Florida/Kristen Bartlett)

“We feel it’s very cost-effective research and convenient for consumers,” said Dinesh Shah, a professor of chemical engineering and director of the UF Center for Surface Science and Engineering.

Shah and Daniel Carter, a doctoral student in chemical engineering, will publish their second article about their research this month in Langmuir, a surface science journal. UF has applied for a patent on the research, which was funded with $200,000 from Procter & Gamble, a major manufacturer of laundry detergent and related products.

More than 56 percent of Americans own electric dryers, with a typical dryer handling 300 loads per year, Carter said. With the average load requiring from 2.7 to 3 kilowatt hours of electricity, that means drying clothes equates to 5 percent of total residential electricity consumption, costing $2.6 billion annually, Carter said.

A conservative 10 percent reduction in drying times would save consumers $266 million annually. But Shah and Carter say they can do better than that.

Their invention: A water-shedding compound created from a mix of common detergents and fabric softeners.

Carter and Shah said the researchers’ key insight was that the spaces between tiny fibers in the weave of fabrics comprise minute tubes, or capillaries, which retain water due to surface tension. It’s the same phenomenon that causes a submerged straw to hold water when covered at the other end and lifted out of the surface, Carter said.

The researchers reasoned that reducing this surface tension would reduce the water retained by fabric. They first tested this idea using finger-sized copper containers dotted with drain holes. Filled with fabric and water and placed in a centrifuge, the containers mimicked the conditions of spin cycling washing machines – except that the water loss and fabric retention could be easily measured.

When the researchers discovered that some compounds apparently increased water loss, they expanded their experiments to bigger fabrics and a real washer and dryer. The dryer sits in a crowded lab on a scale, allowing Carter to compare different wet loads by weight to their total drying times.

Their experiments revealed that one ratio of a common detergent and fabric softener – five parts detergent, one part fabric softener – added before the spin cycle forced the clothes to shed 20 percent more water than untreated clothes. The clothes then dried 20 percent faster.

Source: University of Florida