Why nanolayers buckle when microbeams bend

An x-ray beam just 100 nanometres in width functions as a "nano-magnifier" to explore, in detail, defects and changes in carbon fibres. Image: Max Planck Institute of Colloids and Interfaces

In a novel physical experiment at the European Synchrotron Radiation Facility in Grenoble, researchers from Potsdam, Germany and Vienna have threaded both ends of micrometre thick carbon fibres through thin hollow needles in order to form fibre loops. The fibres are stretched on the outside of the loop and compressed on the inside. In-between there is a neutral zone, as we might find in a bent beam. By tugging on the ends of the fibres, the scientists were able to adjust the loop's radius, and thus also the mechanical load in the tensile and the compression region.

Oskar Paris from the Max Planck Institute of Colloids and Interfaces explains that "what is unique about the experiment is that we can make observations at many length-scales and thus gather evidence about the secret of "nano-buckling". Using a 100-nanometre wide x-ray beam, we can scan the differently distorted regions along the cross-section of the fibre. Our nano-magnifier - the diffraction of the x-ray beam -allows us to measure the local strains of the only some nanometres thick carbon layers, as well as their orientation with respect to the fibre axis."

High-tech carbon fibres are made of graphite-like carbon sheets with strong covalent atomic bonding within the sheets, and weak Van der Waals bonding between them. Almost all the physical properties - and particularly mechanical behaviour - of these materials depend on their orientation. Their tensile stiffness is as much as five times higher than that of steel, and their specific tensile strength can overcome that of steel by a factor of ten. Under compression, however, the fibres can fail. Here, the mechanical behaviour is determined by mechanical instability - carbon layers buckling at the nanoscale - in addition to the shearing of single carbon layers.

In spite of this, some carbon fibres exhibit astoundingly good shear properties. In these cases, "nano-buckling" is rarely observed - which suggests the existence of a substantial number of strong cross-links between the carbon layers. Herwig Peterlik from the University of Vienna explains that "if we could reinforce the usually very weak connections between the carbon layers in a controlled way using this kind of covalent cross-links, then in addition to carbon fibres, the highly-vaunted new carbon nanotubes would be almost ready to make the strongest ropes in the world."

This has been possible very recently with electron irradiation, which requires however a high expenditure of money and energy. The high price is also the major reason why carbon fibres, which are relatively cheap to produce, are not easily replaced by modern nanotubes. The question why these valuable cross-links occur only in some carbon fibres, while others buckle, still remains unclear.

Source: Max-Planck-Gesellschaft